I think I will be going with RAMPS ultimately as it seems to best meet my needs from what I have seen so far. I was just wanting to make sure that I wasn't missing something important. Thanks again! Dogstarby Dogstar - RAMPS Electronics
Thanks everyone, you've been very helpful. I think my question has been answered - RAMPS should be able to meet my needs. Two last questions: Are there any other electronic setups you would recommend over RAMPS? And: Where can I find out more about working with motors (and how not to burn out my circuit boards)? Dogstarby Dogstar - RAMPS Electronics
I've been following the reprap project for some time but am a bit new to the actual technical aspects of it. I've decided to take the plunge and have purchased a printhead from QU-BD. I have a pile of discarded printers and scanners that I hope to cannibalize for parts to make a repstrap (and if those don't work I can always purchase some NEMA servos). My primary question is what controller electby Dogstar - RAMPS Electronics