Okay. Thank you for all of your help.by nerdonator - RAMPS Electronics
I am almost certain that all of my hardware is good. Im pretty sure that the problem is software. I would like to use Marlin, but I dont know how to set everything up. I have KH42J steppers. They are the 6 wore kind, and I cut the unneeded wires to make them 4-wire (I know that I did this right). If there is anything else you need to know about my printer, please reply.by nerdonator - RAMPS Electronics
My PCB is fine, and I have replaced the driver from the Y axis with all other drivers. The result is that all drivers are good, and I am only using one motor and on cable to test them all.by nerdonator - RAMPS Electronics
I have checked many times, my steppers are wired correctly. The motors that arent working, other than E1, aren't getting voltage at all.by nerdonator - RAMPS Electronics
-RAMPS 1.4 Test Code -Y and Z motors work fine. -There is no power to E0 and X motors. -E1 motor locks up -Marlin Firmware + Pronterface -I can connect, but none of the motors move when I print or do manual control. -Sprinter Firmware + Pronterface -I can connect, but motors just vibrate when moved Thank you for all of your help.by nerdonator - RAMPS Electronics