its a 4v-6v servoby garetjax224 - RAMPS Electronics
i found a 12v to 6v converter on amazon i went ahead and got 2. i'm going to run the power off it to the servo and bypass the board. think i paid about 5$ for these not too bad and i think this will fix all the problems on the servo end i can get a link to the converter i got if anyone needby garetjax224 - RAMPS Electronics
i found it... due to me using a LED strip power supply i need to get a 12v dc to 6v dc converter to run the servo off of. at least this is what i'm reading on another page. this will also stop the servo chatter that a get wile printing. just not sure if this is the best way to go still looking around.by garetjax224 - RAMPS Electronics
i looked in the wiki and did not see anything on it am i looking past it? please helpby garetjax224 - RAMPS Electronics
i'll check that out thank youby garetjax224 - RAMPS Electronics
ok here goes nothing i start the print no usb plugged in and everything heats up great, steppers move fine, but when auto leveling starts and the servo goes to move in to place the printer shuts off then back on. when the usb is plugged in everything is working fine. anyone have thoughts on this? before this happened it was running fine then started running off to one side randomly in a prinby garetjax224 - RAMPS Electronics