Hello again I have just wired up my velleman k8200 3d printer to run off of a ramps 1.4 and everything seems to be functioning apart from the Y axsis if I press the button to move it nudges like .01mm and the stop completey. I have checked wiring, endstops, and stepper drivers. All seem to be fine but y don't work any ideas I could try? Thanksby veggienuts - RAMPS Electronics
Quoteo_lampe Sounds like your LCD-encoder switch is damaged. What Shogun tried to tell you is #include U8glib.h, but the forum software doesn´t allow those brackets... #see attached pic -OlafThe seller that I purchased this LCD from sent it to me in a poly postal bag with no bubble wrap or anykind of protection so that would not surprise me if some thing was damaged the SD slot was a bit masheby veggienuts - RAMPS Electronics
Quotedc42 Are you certain you have the 24V supply + and - connections connected to the RAMPS heated bed input the right way round?Yes 100% sure I have a 24V PSU and as far as I can tell it is wired correctly. Repiter is showing the temp it just not stopping it when it gets to the default temp setting, it just keeps heating.by veggienuts - RAMPS Electronics
Hello I have wired up a 24v power supply for my heatbed on my 3d print and I am having issues I hope you guys can help with. The issue is the heatbed once power is supplied it is right away heating the bed I should have control over it but I cannot turn the power off other than by turning the socket of. Does this mean the mosfet is no good?by veggienuts - RAMPS Electronics
QuoteShogun try this #include #ifndef CONFIGURATION_H #define CONFIGURATION_H #include "boards.h" //LCD and SD support #define ULTRA_LCD //general LCD support, also 16x2 #define DOGLCD // Support for SPI LCD 128x64 (Controller ST7565R graphic Display Family) #define SDSUPPORT // Enable SD Card Support in Hardware Console //#define SDSLOW // Use slower SD transfer mode (not normally nby veggienuts - RAMPS Electronics
Hello I bought a ramps 1.4 and a full graphics LCD I have loaded the firmware with all neccessary firmware changes to activate the LCD. When I put power to the unit the LCD emits a high pitch sound and the screen dispalys, but I cannot select anything from the menu and if I push the button it just flickers back and forth from the temp display to the menu. Also at this point the ramps is not conby veggienuts - RAMPS Electronics