Its set as the default(cura). The nozzle is correct ive just checked. As a side note. Prints seem fine with no support. Which is ok as long as i dont need it. But if i try to add a raft etc it gets messed up. Could it be my support details? Its only setup standard... Update: i removed the raft. Tgeres a little bit of support (selected touching buildplate) and its spot on after 2.5 hours. So looby Jmtech - Delta Machines
Any ideas why this is happening? Just finished building it. Cube etc prints ok. Although all 4 corners seem to curl up? It starts off so well. Then eventually hits the printer or similar. Not sure but one of the pictures it seems to have blobbed out? Not sure if its relate to cura generated supports? Ive used rafts etc. But the support generator misses loads (e.g. did an iron man faceplate. It cby Jmtech - Delta Machines
All triggered. Wiring issue. Im such a tool. Did it according to the board instead of the config. Doh! Life saver! Jby Jmtech - Delta Machines
Wow. Çheers! Z min open. X y and z max triggered.... how bizarre. Most likely cause? Firmware is preconfigured by the supplier.... but wonder if its wiring or config.... Thanks in advance Jby Jmtech - Delta Machines
Hi! Got a new delta. Loved the build. Its an Anycubic plus. Problem im having. When i send Home to the printer (code or on the interface). It doesnt go up. It goes down. But it doesnt try to home. Each motor in turn lowers a few mm. Then if i press it again, the same thing happens?by Jmtech - Delta Machines
Hi. I have an issue where my prints keep failing. I tried printing a cube but it printed ok 'theve was a strange wave in one of the sides. But was consistent on all sides. I decided to print it diagonally after noticing stramge behaviour with a raft. Looking down at the printer the raft moves diagonally up and right. Then moves up a little then return in parrallel. But it doesnt. It moves ul. Tby Jmtech - RAMPS Electronics