Pins D30 and D31 do not seem to exist on EXP 3, D14 is the last pin. Is there another designation for these pins?by Nick999 - RAMPS Electronics
Hi, trying to accomplish same task, relatively new to this so can someone post a picture of pins used please? Also, how are pins configured in Marlin?by Nick999 - RAMPS Electronics
Many thanks, I have had a look at Repetier firmware but it seems a little daunting, there are a lot more parameters. Are the values shown in the configuration menus defaults?by Nick999 - RAMPS Electronics
Hi, this is my first post so I hope it is in the right place. I blew the voltage regulatoe on my P802's Melzi board and it was suggested I use a RAMPS setup as a replament. I decided to fit dual extruders. So, I bought an Arduino Mega, Ramps, 6 motor drivers and a DIV268BN as the vendor said RAMPS does not support 2 z drives and it was his reommened driver as it would supply the higher current nby Nick999 - RAMPS Electronics