Hallo Skimmy, wie weit bist Du denn mit deinem Umbau? Könntest Du mal aktuelle Fotos hochladen, ich überlege auch mir Deine Version nach zu bauen. Interessant fände ich auch mal Fotos von Druckergebnissen. Ist die im Thread verzinkte zip mit den geänderten Teilen noch aktuell, oder hat es da noch mal Änderungen gegeben? Ich habe derzeit einen Mendel90, bin aber mit den Ergebnissen nicht so zufvon c.radi - Projekte
Hallo, Wie wäre es mit so etwas: Netzteil Nicht ganz billig, dafür in einem ordentlichen Gehäuse mit Schutzleiter, und einer Anzeige zum Strom. Habe ich heute bestellt, kann also leider noch nichts zur Lautstärke sagen. Gruß Christianvon c.radi - Elektrik & Elektronik
@ scv36: Die habe ich schon vor ein paar Tagen bestellt. Schluckt der Mosfet im RAMPS so viel, dass es mit den SSR dann geht? Ich werde es versuchen. Danke und Gruß Christianvon c.radi - Projekte
@ Skimmy, Danke für den Link, das Heizbett ist derzeit leider nicht verfügbar. Ich habe ein Mk2B mit 12V betrieben am RAMPS. Ich brauche ca. 15Minuten, um auf 110 Grad zu kommen, bei Glas. Mit Alu habe ich es nicht über 100 Grad geschafft. Gruß Christianvon c.radi - Projekte
Hallo Skimmy, könntest Du bitte mal einen Link zu Deiner Heizmatte posten. Ich finde da leider nichts passendes. Bist Du mit der Heizleistung zufrieden? Danke und Gruß Christianvon c.radi - Projekte
Hello, here is something new. Extruder works. The Temperature was to low for extruding. Now i have new Problems. I use an other Hot End then hophead. This is taller, so the cooling don´t work. I must do some rework on cooling and post an new state. Regards Christianvon c.radi - Mendel90
Hello, thanks for your reply. I will make some tests with other slicer profiles an reduce the speed and increase the temperature. @nophead: I use an 1.75mm Hotend and made Changes to the rod so that the idler Block will press the Filament to the hobbed Screw. It works in the test mode. Thanks Christianvon c.radi - Mendel90
Hi, i have build a Mendel90. This is my first 3D Printer. It is not the Kit from Nophead, I build it my own. I use an Ramps an have done the Calibration as in the Manual described. Everything works fine. No i want to print first parts, the Android "man" like shown in the Manual. I downloaded one fron Thingiverse an sliced it with slic3r. The Printer starts zu print, the first layer is fine. Witvon c.radi - Mendel90