Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
Is there anything else i can try that may have caused that hole. I wont be able to test any changes for another 2 more hours but i would like to have as much information as i can.
by
c172cpt
-
Printing
I calibrated the extruder with the hot end removed so that there can be no resistance to cause any slipping, is this a good or bad idea?
by
c172cpt
-
Printing
I will tighten it up and try again, maybe that will fix the infill issue, but would would cause that hole in the side?
by
c172cpt
-
Printing
I am forever stuck calibrating my printer, it has been a month so far of printing only calibration parts. Last night i was finally able to move on to a new calibration part, the 50mm tower. About half way through there was a hole in one of the sides (see attached) and im not sure why or what may have caused that. Also if you nottice the corners of the tower are caved in, the infil was set to 1
by
c172cpt
-
Printing
I am having a hard time figuring out what i need to change, first off my nozzle is fairly blunt and it drags and plastic around that is not in place properly and makes a bigger mess, i am going to machine the nozzle to be more pointed. But other than that i have attached a picture of my first 3 20mm boxes (left to right is the order they were printed) and they look awful to me, i have also attach
by
c172cpt
-
Printing
I am looking for some assistance in indy, i am new to reprap, i do not understand the calibration and how to get the firmware to work, i have been searching for many many many hours.
i have the ramps 1.4, arduino mega 2560, pololu a4988 stepper drivers, and nema 17 motors, i live on the east side, maybe we could meet up some where
by
c172cpt
-
RepRap User Group Indiana (Indianapolis)