Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
Hello Community,
I've got some Issues with my printed Parts (using Prusa Mendel):
links:
overview
top
bottom
It seems the nozzle "run over" the part, flatten it, and at one point it "disengage" itselfs from the Heatbed.
Also i can't set the Z-Axis way to get up over 0.5mm. (using Sprinter FW and Pronterface).
Temperatures tried: Hotend: 215°C to 240°C; Heatbed: 110°C. (Pending 110°C to 115°C
by
essigwurst
-
Printing
I will try now PSU's with higer rating and check the fuses. If i power it directly from a ATX, and put another ATX at the Ramps, it work too.
by
essigwurst
-
Printing
So, maybe it can be solved when i swap the two fuses or install one with more amps?
by
essigwurst
-
Printing
Hey all,
I've got a Issue with my MKII Heatbed: It's heating about 30 degrees, and then it turns off. (Voltage Drop from 11.85V to 0.3V) everytime. Doesn't matter if Printing or just Heating. I'm using two ATX Power Supplies. 19A+16A.
Software:
Sprinter FW
Pronterface
Hardware:
RAMPS 1.3
Prusa Mendel
DELL Power Supplies.
by
essigwurst
-
Printing