Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
Hi Komb, Alzibiff,
I'll take a photo of my test cube tonight and post it. I did a Z calibration with a sheet of paper yesterday and I did verify that I'm printing 3mm filament.
Thanks again!
by
rteslow
-
Printing
Hi All,
I was hoping I could get some input with my prints, I'm very new to this. When printing it seems as if my extruder is dragging over the print and I'm not sure which setting to change to resolve this, I'm using Slic3r if that helps.
Thank you,
by
rteslow
-
Printing