Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
The firmware that we are using is Arduino 1.0.5-r2. The number already matches the thermistor that we have which is Type 1.
We did some testing of both extruders.
On Nozzle 1 we had...
Computer Set Value Computer Read Value Actual Infrared Value
300 259 180 (With Kapton insulation)
The
by
Davis3Dprinting
-
Printing
We used Arduino IDE
Thanks,
by
Davis3Dprinting
-
Printing
Hello Victor,
We greatly appreciate your help.
Would it be possible to send us instructions on how to calibrate the thermistor settings.
Best regards,
Savvas
by
Davis3Dprinting
-
Printing
We have a new X400 that was purchased assembled by German Reprap. We haven't been able to print any parts for couple of months. German Reprap has not been able to diagnose any of the problems. We have determined that the repetier host extruder head temperatures read-out displays temperatures approximately 60 degrees C too high. Example: We set 280 Degrees C, the software shows actual: 250 Degrees
by
Davis3Dprinting
-
Printing