Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
Where did you place your endstop for the x-axis? On the motor side or on the other side? Try to control your printer from the print panel in repetier or with pronterface/printrun. Going minus should be towards the endstops, going plus should be away from the endstops. If the controls do the opposite than you can fix this in 2 ways. First is quick and dirty: just reverse the connector of the stepp
by
joadalama
-
Printing
It turns out to be a glitch in the firmware. I made new files with the online generator of repetier and it worked out fine until there was another layer shift. But that had something to do with the adjustment of the stepper drivers. Now it's printing fine and I can start finetuning.
by
joadalama
-
Printing
Thank you both for your reply. There is only extruder specified. The thing Waitiki noticed could be an issue. I will look into that and report back.
by
joadalama
-
Printing
Hi All,
First a small introduction. I'm a newbie in the 3d printing world and started to built my own printer a few months ago. It's based on a Prusa i3, but the frame is built with heavy extruision profiles. I sourced the parts myself and now I'm nearly finished building the printer it's time to do some calibration.
But here is where the problems begin. When I print an object (in this case a 20
by
joadalama
-
Printing