Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
I am trying to print out this phone stand and I am getting strange streaks and marks along the print. I tried increasing the temperature of the hot end thinking that the material is cooling too quickly, but that did not seem to fix the issue. I am printing with 1.75mm ABS on a Prusa i2. Nozzle diameter of 0.4mm with a layer height of 0.3mm. I am using 20% infill with a extruder temp of 234C. I th
by
Epycre
-
Printing
Are you sure that your idler is tight enough on the extruder? This looks a lot like my first prints before I realized that the material was slipping.
by
Epycre
-
Printing