Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
Nevermind the setscrew on the beltgear was a little lose. This caused some backlash, because it was only holding it on the very edge of the flat side of the rod. ;D
by
Whatnever
-
Printing
I have a similar problem with an replikeo Prusa i3 (Ramps1.4, marlin)
Left of the center point on the x axis (edit: seems to be left of the center of the model or at least more likely there) infill and lines sometimes seem to get offset in X+ direction. (Have not testet printing a part only on the side where it seems to work good yet)
I have reinstalled every Software component I use, switched f
by
Whatnever
-
Printing