Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
the binding has ceased but its still printing above the bed and its printing center as the front left corner of the bed (printed center of the bed before adjusting), still didn't extrude till a manually pushed some through then started flowing on its own.
sorry for late response schools got me busy and I must have entered my desired password for the forums to quickly now have to reset everytime
by
DeltaDawg13
-
Printing
I can manually extrude. using pla @ 220&210°C. Haven't even tried abs yet.
by
DeltaDawg13
-
Printing
New here have a Prusa i3, I'm using ramps1.4 / arduino mega, and Marlin.
I've tested and swapped the extruder motor and wires it moves when testing but doesn't extrude during prints, also burned out the nozzle with a torch to clear blockage, tried deactivating the "PREVENT_DANGEROUS_EXTRUDE" in Marlin and didn't help or do anything really different. Also The X,Y,and Z all move smoothly & Qu
by
DeltaDawg13
-
Printing
I got similar problems with my Prusa i3, using ramps1.4 / arduino mega, and Marlin. I've tested and swapped the extruder motor and wires it moves when testing but doesn't extrude during prints, gonna try deactivating the "PREVENT_DANGEROUS_EXTRUDE" in Marlin and see if that helps. Also The X,Y,and Z all move smoothly & Quietly with pronterface, but again when printing it there is terrible bin
by
DeltaDawg13
-
Printing