Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 11 of 11
Ciao Dominikx,
probabilmente devi tendere di piĆ¹ le cinghie.
by
Alticcio
-
Printing
Hey guys, after a day printing, all seems to work good.
Thank you and, If you like, take a look at the photo of one of my first, good, print attached.
by
Alticcio
-
Printing
Hi all, increasing the motor current seems have resolved the issue.
by
Alticcio
-
Printing
I was thinking, is it possible to be a driver current issue?
by
Alticcio
-
Printing
What sounds really strange is the identical error on the 2 axis. It's like some math gone bad.
Nozzle and bed are not moving after G1 move.
by
Alticcio
-
Printing
Same delta for every case.
x(y)10 to x(y)160 it's 148
x(y)10 to x(y)160 it's 148
I tried the test you suggest, moving x by 0.1 repeteadly.
It seems like moving on +x , the axis moves for every step, but moving on -x it moves one yes and one not.
Edit. even moving from 10 to 20 same result, almost 8
by
Alticcio
-
Printing
I measured the distance between x10 and x110 and is 98, same for Y axis.
by
Alticcio
-
Printing
Pulleys have 20 teeth.
Maybe some setting in Marlin is scaling my print?
by
Alticcio
-
Printing
Hi JamesK,
I'll count the tooth in the afternoon, after work.
When I read the list of components, It said "20 tooth" and I haven't checked.
For "each axis" I mean also Z.
by
Alticcio
-
Printing
Thank you.
So, all I have to do is to calculate the right number of steps with this(?) formula
CorrectedStepsPerMMValue = (20 mm*CurrentStepsPerMMValue)/(MeasuredSide)
and corret the value in configuration.h, right?
by
Alticcio
-
Printing
Hi all,
in the last few days I have built my first 3d printer, a prusa I3 pro B.
All seems to work fine and prints are nice except for measure. My test cube is 17,5mm on each axis instead of 20mm.
I have 20 tooth timing pulley and gt2 timing belt with steps setted to 80.
Every tip is welcome
by
Alticcio
-
Printing