Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
Hi!
I have this strange problem that when I try to print solid surfaces they have gaps between the printed lines.
I have calibrated extrusion steps and extrusion multiplier.
My nozzle is Volcano 1.2 mm and extrusion width is 1.5 mm. I have tested extrusion width with 40x40x10 mm 1 perimeter block and the width of the shell was 1.50 mm.
Do you guys have some settings for me from simplify3d to
by
puolikas
-
Printing
Hi!
Good way to prevent corner lift is to print like this:
1. Clean your bed properly with alcohol
2. Add an even layer of blue tape or something else
3. Clean the layer with alcohol
3. Heat the bed to 60 degrees and turn it off when you're about to print
4. Start printing and remember to use brim (I use 10 mm brim)
I had big problems with PLA but now its working perfectly.
My nozzle temp is
by
puolikas
-
Printing