Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
I found the section in the code where the timeout value was set. I had mine at 10 seconds. I increased it to 60 seconds and tried to run the print again and it still threw the error.
by
Matt 629
-
Printing
@DaGameFace thank you for your response. Ill make sure to check that this is not the issue.
by
Matt 629
-
Printing
Hey guys,
I am new to this forum but I have been 3D printing for a while now. I made my printer from a kit online that uses an arduino board and marlin softwear I believe. In the past I used PLA to print and have never had an issue, but the other day I tried printing ABS. Because I was printing ABS I increased my bed temperature. I set the temperature to 80 degrees Celsius and let the print star
by
Matt 629
-
Printing