Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 6 of 6
Hi DLC,
Thanks for the comments. I'm only printing via SD card and have tried three different SD cards, two different SD card readers, fresh installs of the recommended version of Cura. I got the original firmware from the manufacturer and reinstalled the firmware completely but the problem persists. I attached a video of the behavior I'm describing:
Let me know if you have any thoughts. I fe
by
ellis83
-
Printing
Hi Imqqmi,
Thanks for the reply. I'm not actually sure what board it is using, but I know the firmware is some custom version of Marlin. I would like to reinstall it to see if that helps the problem, but I don't actually have the custom build of Marlin for this printer. I can try to contact the manufacturer to ask for it. The filament at the extruder is breaking during the quick retractions.
by
ellis83
-
Printing
Hi Everyone,
I have a Clone3D K200 3D printer (http://www.clone3d.co.kr/K200.php). A set of problems have popped up out of the blue. During my prints, the printer will run a bed auto level as it always does and begin printing normally. However, seemingly at random times it will return to the X home, hit the limit switch, and return to the print position to continue printing. It also is doing thi
by
ellis83
-
Printing
I changed the USB cable and port I was using on my computer. Nothing seemed to change and I'm still getting the same errors and behavior.
Does anyone know if there may be a section in the firmware that would be pushing the auto home command? I have a second one of these K200 printers I use for normal 3D printing and that one also does the exact same enqueueing of G28, G29 and G1 Z1 when I try t
by
ellis83
-
Printing
That makes sense that with the SD card
working as it should. I'll give that a shot. Thank you for the reply!
by
ellis83
-
Printing
Hi all,
I'm using Repetier host to deliver Gcode to my 3D printer. I'm sending fairly simple Gcode generated by a python script with move and extrude commands. If I save the Gcode to an SD card and run it it works as it should, but if I add it to the Gcode Editor in Repetier host and run it, the printer starts running the Gcode, but will enque the following three commands in the middle of the pr
by
ellis83
-
Printing