Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Good points, I have wondered about the effects of other equipment as I notice fluctuations when my water pump starts etc.
It looks as though imqqmi has picked it though.
My acceleration was very slightly too high on the Y axis.
I am having other problems now so still can’t be absolutely sure but will keep trying.
I would definitely recommend to anyone building a scratch built printer to run
by
351bronco84
-
Printing
Okay, thank you for your advice.
I will try the gcode today.
The heat sink is not even warm to touch.
I am thinking of taking the heat sink off so I can check the chip itself.
Cheers
by
351bronco84
-
Printing
Hi, I am sending myself crazy trying to find the issue that is causing my prints to shift after a couple of hours.
It happens every time when dual extruding the design in the image.
If I scale it down to half the size (and time) it prints okay.
I have had it happen on another single colour large print but not consistently like this dual extrusion print.
It is at different layers and in different
by
351bronco84
-
Printing