Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Thanks. I just checked the x axis and they where slightly off. I reprinted x axis holders and it is now perfect. I did a few test prints and it had no effect. I checked the y axis and it seems to be off quite a bit. The rails don’t appear to be level. It appears to be the metal extrusions need to be readjusted. I will adjust them and follow up.
by
Matt225588
-
Printing
I believe it's version 1.1.9. I was unable to get 2.0 to compile. I have enabled "#define RESTORE_LEVELING_AFTER_G28" but I had to disable it because it makes the first layer uneven.
by
Matt225588
-
Printing
Hi, have an Anet A8 that I swapped the Frame with metal extrusions. I have been working on this printer for about 2 years and I cannot get the auto bed leaving to work properly. I currently have a BL Touch see the reading on the bed attached. With just the G28 command I can print just fine; however, when I use G29 it seems like it is un-leveling the first layer. No matter how many times I relev
by
Matt225588
-
Printing