Show all posts by user
Printing issues ...
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
Ok, so i solved a few things.
1. XY offset was due to stepper's reading incorect. Did not set 40 steps / per mm instead of 80 in the FW. Found this by a lucky coincidence since i wanted to set the offset in FW and was checking how the printer was reading this stuff. Got my attention when it showed -140 in home position. Solved this for Y and Z axis. Now after calibration my prints are ok (previ
by
sass0
-
Printing
Hey guys,
Well, im new to 3D printing and dont actually quite know where to turn for support but i hope this will do.
So, i bought a DIY printer that some guy did out of aluminium with quite nice bits and pieces to have a sturdy frame, a nice heated bed sitting on linear profiles etc. 2 steppers for the Z axis, one for X and Y.
The printer runs on Fysetc F6 board with TMC2100 for Z and E0, TMC
by
sass0
-
Printing