Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 7 of 7
Quote3dim
To my knowledge, there is no part being a barrier when porting 3DimMaker to linux. For sure there will be some minor fixes required - linking of libraries, small code fixes arising from a different compiler, etc. But we alredy have the Mac port so I belive the linux one won't be so difficult to prepare...
...
Sorry for unclear formulation. For sure, it will be open source for everyone
by
teppic
-
Crowdfunding Projects Announcements
I have to say that I find this interesting, and it definitely looks like a capable piece of software.
I'm definitely going to try the current free version as soon as possible. Have tried loading and slicing a model, and it seems promising.
Like some already have a couple of slicers, but I'm sure this one can bring something new to the table. I don't really understand the "we already have x and y
by
teppic
-
Crowdfunding Projects Announcements
arejay: I came to the same conclusion early, but I was determined to figure out what exactly was causing the problem. I have since made a lot of test prints and carefully studied exactly what happened and I'm quite sure that I have found the problem.
This is the issue that joecarpita linked to in his first post -
I think this is the cause for most of the quality problems you see in 1.2.9. If I
by
teppic
-
Slic3r
Perhaps it's a port issue. "Vanilla" octoprint runs on port 5000, but if you run octopi you'll get a reverse proxy/webserver that listens on port 80. Not sure what port Slic3r expects it to be at, but this could be a problem depending on your setup.
Also, perhaps obvious, but i assume that you also have enabled the API in the settings
by
teppic
-
Slic3r
I'm not entirely sure, but I think you need a development version of octoprint, since the stable version has an incompatible API.
Also, I have myself made the mistake of just copying the url from the browser- which won't work, but you have to make sure that the IP-adress is "clean", i.e. no http-prefix or trailing slash.
Hope this helps
Edit: I didn't notice that new stable octoprint was actu
by
teppic
-
Slic3r
I have a similar experience. In fact i have had problems with 1.2.6 and upwards.
I think that some default settings in 1.2.9 aren't optimal, but I have been working my way to a pretty decent result. I intend to make a post about the experience.
Basically, my starting point was the default setting (from the wizard), but I tweaked the temperatures, which was my primary mistake
This is relevant f
by
teppic
-
Slic3r
comwarrior Wrote:
-------------------------------------------------------
>
> >>> skeinlayer.py D:\StepperGearmini.bfb
> File "", line 1
> skeinlayer.py D:\StepperGearmini.bfb
> ^
> SyntaxError: invalid syntax
>
>
> The ^ is pointing at the D in D:\ so my question
> is can it handle the drive letter or does it have
> to be relit
by
teppic
-
Skeinforge