Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 4 of 4
No worries! Post of picture of that SL print!
by
anXofY
-
Slic3r
Have you successfully saved with other settings changed? Is this specific to "yes/no" options? Is the file being written at all, or is there a chance that it is writing the config.ini to another location?
by
anXofY
-
Slic3r
Wahoo! Perhaps I was moderately helpful in my first post!
by
anXofY
-
Slic3r
Yup, I am pretty sure you are in the right place! What version of Slic3r are you running?
Can you also please provide the following settings from your configuration:
Nozzle Diameter
Layer Height
Default Extrusion Width
First Layer Extrusion Width
Bridge Flow Ratio
If I understand the output you provided, you have set up a .1mm nozzle diameter and a 0mm layer height. The layer height would cert
by
anXofY
-
Slic3r