Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
I'm getting even steps for all axis when changed gantry style to Cartesian printer so the issue has to be somehow related to the corexy part of the firmware, @Repetier, do you have any further suggestions? thanks!
by
Rav
-
Repetier
thanks Repetier, I have followed your suggestion and changed frequency for double steps to 50000 and 70000 and stepper_high_delay but it didn't change anything. I have even replaced stepsticks but this didn't change anything either :/. I have ordered another RAMPS board as i tested COREXY on my old one today and it worked perfectly. I'm not sure if this issue is related to the firmware or to RADD
by
Rav
-
Repetier
it looks like someone else has exactly same issue , I have probably tried all possible settings in repetier firmware but without luck so far..
by
Rav
-
Repetier
I'm using A4988 stepsticks, I have changed STEPPER_HIGH_DELAY like you suggested but unfortunately it didn't fix the problem, still one of the motors stepping seems to be lower than the other one. It's a bit weird and I'm not sure if it's related directly to the stepping.. for example when I move the carriage in the X+ direction the feedrate seems to be approx. 2x faster than when moving it in th
by
Rav
-
Repetier
I have exactly same issue here with RADDS board . have you found any fix for this?
thanks
by
Rav
-
Repetier