Show all posts by user
Page 3 of 3
Pages: 123
Results 61 — 62 of 62
Hello everybody!
In my dual extruder configuration (direct drive) I activated the extruder cooler fan feature for each extruder:
Quote
#define EXT0_EXTRUDER_COOLER_PIN FAN_PIN
and
Quote
#define EXT1_EXTRUDER_COOLER_PIN FAN2_PIN
After heating up the extruders in repetier host only the fan for extruder 2 starts automatically, while the corresponding for extruder 1 stays still. The fan 1 can o
by
Reparator
-
Repetier
Hi,
I´m setting up a dual extruder Ordbot Hadron in the moment and most of the mechanical settings are working in the meantime. As firmware I use repetier 0.83 on an Azteeg X3 board from Panucatt. Control software is Repetier Host on Windows (0.90c)
The critical point I´m struggeling at the moment is the setup of the thermistors, especially the one for the heatbed.
Extruder 1 and 2 are working.
by
Reparator
-
Repetier
Page 3 of 3
Pages: 123