Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 5 of 5
Tried to install RepetierHost on raspian hard-float version but this version does not properly support mono. A problem with the fact that rpi is armv6 with hf makes troubles. Mono thinks that if hf is supported by the CPU thus it can handle armv7... Some guy tried to recompile mono with patches but it seems to be complicated. I'll try with raspian soft-float in a while. Stay tuned
by
hoani.cross
-
General
richgain Wrote:
-------------------------------------------------------
> Hi Rich
> I'm still trying to print a copy of Tiny Planetary
> Gears that I can actually assemble!
> I've used your settings in Slic3r 0.8.4 and also
> played around with nozzle size and extrusion width
> a bit but I'm consistently getting holes in the
> planets that are smaller than the posts they are
by
hoani.cross
-
Competitions
Here's my second (and most likely my last) try with the same parameters as my previous print except that I set the layer height at 0.18mm, the Z-lift retraction at 0.2mm, the infill at 40% (honeycomb) : I get much more - tiny - strings
My first try at 0.3mm layer height close ups :
And last, all my tries from right to left, my first try (0.3mm layer height), my second successfull
by
hoani.cross
-
Competitions
Nice improvements john however, I must honestly admit that I will not find the courage to unscrew all the x-axis... I already spent SO MUCH time on the H-1, I need to get to real life some time
Concerning the linear bushing, I'm actually using my seft printed PLA linear bushing for my y-carriage and I'm very happy with it ! You can get a good preview of my progress on my G+ blog. Maybe I'll ge
by
hoani.cross
-
Competitions
Hi,
This is my first try for this competition using my modded SeeMeCNC H-1 :
Budaschnozzle 1.1 with adapter for the original Steve's Extruder Custom fan duct Huxley PCB heated bed RAMPS 1.4 And some more hacks
My first print was using those parameters :
0.3mm layer height 20/40/60mm/s for small perimeters/perimeters/infill 1mm retraction length at 7mm/s with 0.3mm z-lift 70% line infill 2 pe
by
hoani.cross
-
Competitions