I get the same problem. It does not see the head heater. I have found that warming it a little with a heat gun and then sending M562P1 and setting the temp.by IBDunne - Ormerod
I've sorted the wiring, and it prints again!! The stalling mid print seems cured, touch wood. I still have a strange problem, when I first switch on I have to use a hot air gun to warm the hot end and use M562 code to get it going. One thing that surprised me, was that the new firmware makes printer sound different. Thanks for the help.by IBDunne - Ormerod
I had got my ormerod 1 going but, then it began stalling on prints that had worked a day before. I could find nothing wrong and it was only on some files. I have just updated the firmware to the latest version 078b, now the proximity sensor is giving very low readings, 280 at Z0. Any ideas about either problem appreciated.by IBDunne - Ormerod
Ok so I just down loaded the raw data. I admit I am out of my depth, how do I do anything with it? I am sure this is a stupid question but how do I compile?by IBDunne - Ormerod
A lot to think about, I''l try the fork and see what happens, once I have a couple of other little probs sorted.by IBDunne - Ormerod
I had a similar problem on my new machine and the the same firmware. I tried reloading the firmware and the problem went away. I do not know why and I still have other problems but that one went.by IBDunne - Ormerod
I'm using 65e. It seems to be with a particular file, pronterface stops at the same point each time. I tried a different scale version of the same file and it stalled again but this time at a different place. PC not going to sleep or anything else connected. Cheersby IBDunne - Ormerod
My new ormerod has been stalling in mid print. Just stopping and not responding to pause or anything. I am using pronterface. With a particular file, I have to disconnect and reconnect, and then start again and the same thing happens.by IBDunne - Ormerod
i'm commisioning a ormeroid, Thermister on the extruder does not work, I get a reading of -273. At the plug connections I get 120KO resistance (room temp) dropping to 10KO when I heat it with hot air gun. The pins have 3.7 V on them from a simple usb connection. Putting a small resistor between the pins causes no change in the reading. What to try?by IBDunne - Ormerod