Thanks, guys! I will try these solutions tonight. I'm aiming to get to a situation where I'm using vanilla software straight out of the ppa and updating with apt-get. So I'll look at adding a clearNext to the dot file, then update the firmware, and finally look at putting the printer onto ethernet and changing my workflow to use the web interface.by ErroneousBee - Ormerod
I have an Ormerod1, and have been printing fine using the software downloaded when I set it up. Ive recently tried moving to the latest version of printrun (pronterface), and find that prints are stuttering. E.g. a simple ring: Stuttering prints after moving to Printrun 2015.03.10 I assume Ive failed to carry over some settings to do with the way commands are sent from pronterface to the Duet vby ErroneousBee - Ormerod
My next issue is I suspect the Y axis is somehow reversed. If I plug in the power supply, start pronterface, and press the blue Y Home button, it homes to the end away from the motor and end stop switch. Is this correct? I would assume the Y would home the the other end where the switch is.by ErroneousBee - Ormerod
Commissioning my Ormerod 1, I have a couple of problems. I'm trying to work out why my hot end won't respond. Applying a multimeter to the thermistor terminals at the board shows 139.4kOhm (Its about 18degC in here). If connect the board up and Connect to it with pronterface I get: RepRapFirmware is up and running. Printer is now online. Temperature measurement fault on heater 1, T = -28.2672by ErroneousBee - Ormerod