Quotedc42 Are you really certain that the relationship ship between the displayed and actual temperature is changing? That is not impossible if your Duet or thermistor is faulty, but is certainly unusual. Can you check using a multimeter with thermocouple probe? Are the thermistor leads secured so that the thermistor cannot move within the heater block? I do have a multimeter with thermocoupleby Aloderendra - Ormerod
QuoteTreito But it's the best idea to reprint this tower. I agree, but in order to reprint the tower, I need to first be able to complete a print that large. I am not able to at this point due to the temperature problems.by Aloderendra - Ormerod
Quote0x0000 I believe the firmware will stop extruding once the temperature hits 160 to prevent damage to the hotend. Since 170 is quite close to that, maybe it's briefly dipping below the cutoff temperature? This can be overridden by enabling "cold" extrusions with the M302 command, though that's usually only done during maintenance. The heart of the problem is that the board + firmware believeby Aloderendra - Ormerod
I'm completely at a loss as to what's wrong/how to fix it. Printing misc objects with PLA on the Ormerod 2. The problem: At some time interval from the beginning of print, the Ormerod 2 just quits and stops. Stopping the print and trying to extrude manually works just fine, so no idea why it stopped. From troubleshooting online, the reason it stops is the temperature is too low for extrusby Aloderendra - Ormerod