Show all posts by user
Safety...
Page 4 of 4
Pages: 1234
Results 91 — 92 of 92
Yep, that page is how I knew the M words though it didn't quite get me there because I'm not using Omnirod.
I had skimmed through your blog on the duet in general and your kossel upgrade which helped as far as your notes on what the duet was expecting etc.
I have not updated the firmware since it was communicating I just disconnected the usb when it was communicating, plugged it back in the
by
Epop
-
Controllers
I'm new to additive mfg. and most of my experience is trying to get an expensive 3-extruder printer working using 'free samples' provided with the printer- wasn't working. I'm spiteful, going to get something other than more gray hairs from it. I know a little about electronics(taken a lot of stuff apart at least) and am a machinist.
Attempting to convert to Duet+x4, bought it in Feb. but see
by
Epop
-
Controllers
Page 4 of 4
Pages: 1234