Do you have the design for the motor mount from your post? That looks like a good idea, and then the extra bearing can go on the other side.by thanos - Reprappers
It's drifting against the fender washers. BTW, I'm having very similar issues on the X-axis.by thanos - Reprappers
I just added the x-axis last night and sheesh... belt drift again. I think my plan is to tune it as best I can, and then print me one of these (http://www.thingiverse.com/thing:38753) as suggested by an earlier poster... Thanosby thanos - Reprappers
OK, I will give that another shot. I was doing the same 1/8 turn adjustments. Any other pointers you can think of would be hugely appreciated!by thanos - Reprappers
I did that, but no joy. How fine adjustments did you have to make with the front bearing?by thanos - Reprappers
Thanks Pete. My gear does not drift much and I have not added super-glue yet. Did you do anything else to stop the belt from drifting?by thanos - Reprappers
That's kind of what I was wondering, since I have lined up everything very carefully to within less than mm tolerances, and I cannot even get this to be remotely stable on the bearings. Hmmm....by thanos - Reprappers
Hi all, I am having an issue where I cannot get the y-axis belt to not drift left and right (RepRapPro Mendel). I've lined up the bearings as precisely as I can, made sure everything is nice and square, but it still continues to drift several mm and hits the ends as I move the frog back and forth. I can reposition the front bearing and somewhat improve it, but then the back one starts to driftby thanos - Reprappers