Check out these problems that could be present individually or collectively. Z belt over tightened / or motor pulley misaligned Z rods misaligned causing the table to jam Check that table at the lowest level sits on the lock nuts A faulty Z limit switch, loose connections on the board or on the switch itself. Regards, Robby lewers - Reprappers
Check out these problems that could be present individually or collectively. Z belt over tightened / or motor pulley misaligned Z rods misaligned causing the table to jam Check that table at the lowest level sits on the lock nuts A faulty Z limit switch, loose connections on the board or on the switch itself. Regards, Robby lewers - Reprappers
I would appreciate any advice on the following. What are the electronics and firmware required to upgrade a Rapman 3.2 single head extruder; 3.0 mm filament printer to a Greg Wade Extruder with a suitable hot end. Thanksby lewers - Reprappers