Same as before No start signal detected - forcing start EDIT: I tried uploading firmware to mega while ramps was plugged in, no luck, I get timeout error. I am starting to believe that something is wrong with ramps...by pkneca - Reprappers
This is from my first post "after that I tried to connect ramps to the mega and start repetier, and then I get "No start signal detected - forcing start" (no blinking light, always on light on mega)" this is without any cables attachedby pkneca - Reprappers
Hello everyone, this is my first post on the forum, excuse me if I posted it in a wrong section. Recently the board on my Anet A8 died, so I ordereed ramps 1.4 kit. I uploaded Marlin firmware, but I couldnt get the board connected to octopi or repetierhost. Now I tried this firmware LINK, I did not chaged anything, just uploaded it. I dont have the printer near me now, but I tried followingby pkneca - Reprappers