Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 2 of 2
I just did a new Ubuntu16.04 install and installed pronterface. However, I get the error:
Saving failed for set last_window_height:'PronterWindow' object has no attribute 'rc_filename'
at every startup and the window defaults to the original size. Not what I last sized it to,
tj
by
999alfred
-
Printrun/Pronterface
I have found something that I am trying to figure out. Using a 0.3mm nozzle. I have my printer calibrated so that printing the 20mm cube I am only +- 0.02mm. I think that is pretty good.
But when I am printing the dimensions on an inside opening, like a bearing hole, is smaller then the given dimension. I printed a test piece, a square frame with the outside being 30mm and the inside being 20mm
by
999alfred
-
General
