Anyone have any good pla settingS for slicer. My first layer seems to be the issue.by cliferton1 - Prusa i3 and variants
Quoteczmorris QuoteNewtoprinting Can someone help please. My pla has been getting caught between the heat block and the filament drive. It would print fine for 10 minutes and then building up between heat block and fan/ filament drive. It might help if you take a picture of you setup or if the problem is visible the problem itself. Is it the standard unmodified Folger extruder? Also post your baby cliferton1 - Prusa i3 and variants
Quoteczmorris QuoteNewtoprinting Can someone help please. My pla has been getting caught between the heat block and the filament drive. It would print fine for 10 minutes and then building up between heat block and fan/ filament drive. It might help if you take a picture of you setup or if the problem is visible the problem itself. Is it the standard unmodified Folger extruder? Also post your baby cliferton1 - Prusa i3 and variants
Noticed the y carriage would work and sag when it is hot so I drew this up St work and cut itby cliferton1 - Prusa i3 and variants
Ok been at it tonight. I tried the numbers you had posted (79.84, 80,3836.93,101) as a start and the cube was x=19.84mm,y=19.79mm, z 19.62mm. so im still a little off there. How should I go about correcting this? trying to test print some stuff. im having trouble with the part coming off during print. I was using painters tape. now I wiped it with alchaol and have the bed at 80*c. so far this zby cliferton1 - Prusa i3 and variants
messing with it now. so what are the voltages I need to go with on the motors? I saw where you said use the ones you posted bfore but I guess I kept overlooking the ettingsby cliferton1 - Prusa i3 and variants
Thanks for the info. I was off work today but I think I'm going up there tonight to mess with it.i should be able to figure it out now that I know where to look I'll check out that in marlin. I'll keep it updated...thanks againby cliferton1 - Prusa i3 and variants
getting better i guess lol. something is up with my z. x and y seem to have correct scale but z is stretched. i attached a pic of a part we make at work and a slightly scaled down version i just printed. I have not adjusted my stepper voltage no idea if thats going to have anything to do with it or should i be looking at marlin settings. the 20mm cube i printed was 19.98mmx19.97mmx25.7mmby cliferton1 - Prusa i3 and variants
ok here is the video i used for base settings on slicer after i slice im useing pronterface. I think I found the print height issue. it looks like even though i set my two z heights with calipers its still off. what do you guys use as reff points to measure. just reset the z and re leveled bed. lets see if this works. still stumped about inital pla feedby cliferton1 - Prusa i3 and variants
Ok got my folger a couple days ago we had it up the first night after a 14 hour build we made it print a crappy blob and a offset issue. A new firmware load and some settings off here and it seems to be much better. The issue I'm having now is confusing me. I have home set well I think I do z is really close and it will hit the limit switch . I think it is where it should be, but when I start prby cliferton1 - Prusa i3 and variants