Quotebmfcamaro Thank you. I cant imagine the screws backing out enough to cause that, but I guess it could happen. Any ideas for an alternative hookup? Something more secure, maybe actual soldered connectors? Quotekrwynn Only thing that would do that is a bad connection creating heat. ALL parts are listed here with a link to a vendor: http://reprap.org/wiki/RAMPS_1.4 Quotebmfcamaro Hello, It aby SRM - Prusa i3 and variants
Quoteshepp Hello all, I am new to 3d printing and bought and assembled the i3 prusa kit (revb) . A few problems that I need help with, one is the heat bed doesn't show up on repetier host. So not sure if it even works, and two is I bought a full graphics controller that lights up but doesn't do anything else. I've tried different versions of marlin and nothing works for the controller. I thinkby SRM - Prusa i3 and variants
QuoteDriftyDave QuoteSRM yesterday I finally assembled and calibrated my Prusa i3, but after installation of Repetier-host, in Manual Control section I see no temp slider for heatbed. all other settings are ok. does anyone can tell me what I missed. thanks My first thought is to check the bed thermistor and make sure it is connected to the RAMPS properly. Also test to see if the thermistor is fby SRM - Prusa i3 and variants
yesterday I finally assembled and calibrated my Prusa i3, but after installation of Repetier-host, in Manual Control section I see no temp slider for heatbed. all other settings are ok. does anyone can tell me what I missed. thanksby SRM - Prusa i3 and variants
NEED HELP !!! Assembled my recenlty received Prusa i3 from Folger Tech. When turned ON, everything seems to be OK. Start to set current on stepper drivers when I got 3 done, the Ramps switched off with no sign of life. Power supply works fine 12 V on both sides. Does anyone know what was wrong? Thank you in advance.by SRM - Prusa i3 and variants