Quotetadawson Quotehobbes Finally got my printer today. I'm checking all the parts. Noticed through the bag that some parts on this board were bent. Could an expert set of eyes tell me if i should request for a new part or will this work just fine? If it bugs you, bend 'em back vertical, but from an electrical standpoint, unless the tabs are touching, it's irrelevant. In this day and age of chby Garben - Prusa i3 and variants
Quotehobbes Are you guys kidding me? So the estimated delivery is complete bogus? They did print the label a day or two before mine shipped, but I recived it on the Ebay listed delivery date. Just FYI, I ordered some parts last week for another project and the seller printed the label and nothing else showed up on USPS tracking until it was delivered to my adress. So, FT may have shipped it anby Garben - Prusa i3 and variants
Quotemsaeger Working on wiring now and I am to the point where they ask you to connect the heated bed and hot end thermistors. The instructions say to attach the molex connector to them both yourself. Mine has the connector already on the heated bed thermistor but the hot end is bare and they didn't send any loose molex connectors. How did everyone else's kit come? I had some old servo connecby Garben - Prusa i3 and variants
Thanks markts, Here is the case I used for my LCD There are a bunch more to chose from though. This one turned out Ok, but I did have to cut a hole in the back for the plugs on the board. I mounted it on the top bar using mounting tape and zip ties. You could print some t-nuts and use screws, it would look better that way.by Garben - Prusa i3 and variants
Thanks mel0n, The woodfill is Esun brand I get it from Intservo all of my filament is Esun. It seems to work well and the price is right. The settings on the woodfill are the same as with PLA. I ran this at .02 layer height and my extruder was set at 185 with the bed set at 40. I have not checked the actual temps verses what the thermistors are reading but, the printer seem to run a little hotby Garben - Prusa i3 and variants
Hello all, This is my first post on RepRap, but I wanted to say thank you for all your post. I bought the FT 2020 about 3 weeks ago and I had some problems at first (Some of the solder joints on the back of the Ramps board had been bridged. This made it half work until it blow my Mega board.), but FolgerTech took care of me and now I am up and running. I have done a few prints like some fan mountby Garben - Prusa i3 and variants