@therippa, looking at the great print you've made, I can see a tiny little curly piece at the top. I have an issue that I've been trying to figure out and seems it might be present in your print. When my prints are finishing up the last layer, the extruder tends to finish a couple lines early and just tail off to reset itself. Is this something common?by tonyharney - Prusa i3 and variants
I did finally find the solution for this buried in a thread. When connecting the end stops, it's just mentioned in the Build Manual to plug the x, y and z axis stop switches into positions 3, 5, and 7, respectively. It's not mentioned that these are for x min, y min, and z min... where as this new build design uses x max with the right side configured stop switch, so the x axis stop switch needby tonyharney - Prusa i3 and variants
I'm wanting to think my issue is with my FolgerTech Prusa i3 printer, but something in the back of my mind can't quite rule out the Repetier software either. I started digging around on the forums and found that there is a similar x-axis issue that I'm experiencing. The stepper motor gets very, very warm and the commands sent from the Manual Control buttons in Repetier don't coincide with whatby tonyharney - Prusa i3 and variants