Ok i checked the Resistance between the wires and you were correct the cable wires were not correct i have adjusted these! However i still cannot get my motors to run. You mention jumpers (little black clips) under the stepper drivers, i have not put these in as far as i am aware, as the mega board seemed to be fully constructed and i did not have and (black clips to add) Can someone please provby j800shy - Prusa i3 and variants
Hi ok so i took some photos: - I checked the connections all Good I adjusted teh speed to 100. Still no luck. however I have notced that the wires from the conector going into the board are (left to right) green, yellow, Grey, Red. But going into the stepper motors are Green GREY,YELLOW,Red. The grey and yellow are different. Would this be an issue? and is this what the referal to with the 2by j800shy - Prusa i3 and variants
Thank you for the reply, i will check what you have suggested when i get home from work, I will also provide pictures to support the issue that i am having etc.by j800shy - Prusa i3 and variants
No the motors have not moved for me at all! I have tried to home them out, then move the axis but nothing moves? am i missing something? I have followed the steps in the manual?by j800shy - Prusa i3 and variants
I cant get the motors to move while in manual control mode? Need help, I have I3 2020 printer thanksby j800shy - Prusa i3 and variants
Hi all I am a new member on this site and a beginer in the 3D printing world. I have purchased the 2020 I3 Kit and have built the printer. I have followed each step but have come across an issue when uploading the Marlin Software. See error picture attached: - This has been kicking my ass for a little while and any help would be fantastic! Thanks in advance! Update 1/2/15 I have successfulby j800shy - Prusa i3 and variants