My printer has been printing things mirrored on the Y axis. I can flip it in Cura, but would rather fix it on the firmware. I tried inverting the stepper direction, but now the stepper just isn’t moving. Is there another setting I need to change? I also changed the end stop from min to max, and back with no movement.by pRO84 - Prusa i3 and variants
Speaking of extruders, I got a new all metal mk8... Doesn't fit right out of the box. Is there already a known solution to mount the thing on, or do I need to just mod it to fit on the carriage? I had the original one on previously, and this is the common all metal version found on eBayby pRO84 - Prusa i3 and variants
Quotegotswrv Copied right outta slic3r M140 S112 ; set bed temperature doesnt wait M104 S240 ; set extrude temperature doesnt wait G91 G1 Z10 F400 G90 G28 X0 Y0 ; home axes G28 Z0 G1 Z20 F1600 G1 X50 Y50 F3000 M190 S112; set and wait bed temperature M104 S242 ;doesnt wait extruder G1 Z 1 F800 M109 S242 ; set and wait for extruder temperature to be reached My XY position was 110,110 to vby pRO84 - Prusa i3 and variants
Quoteveaceonee QuotepRO84 Thanks for the file. Unfortunately, same result as before. I have no idea whats going on. I tried tweaking a few things, but have no more time tonight to play around. =T Just out of curiosity, what are the pot voltages for the steppers at? I can check later on, but I’m not sure that is relevant. I was getting good quality prints, BUT they were never centered on the bedby pRO84 - Prusa i3 and variants
Thanks for the file. Unfortunately, same result as before. I have no idea whats going on. I tried tweaking a few things, but have no more time tonight to play around. =Tby pRO84 - Prusa i3 and variants
Quotegotswrv pRO84, What motherboard do you have? I can send you mine to try out. I've got one of the electrons btw. Its the MKS Base..1.2 that came with it. The electrons are essentially the same thing right?by pRO84 - Prusa i3 and variants
Ax, Should the points inputted be to center or to the corner of my plate?by pRO84 - Prusa i3 and variants
I have the 210mm square bed. No sensor. I did use your version of Marlin and the correct config file, as you advise. I’ll try to sort it out with what you’ve said and report back! Thanks!by pRO84 - Prusa i3 and variants
Just found this thread, a lot of good info. TONS of pages to look through. Today I changed my firmware to Ax’s configuration file, hoping it would fix some of the issues I had when I originally put my printer together a couple months ago. Unfortunately it did not =( 1. I can NOT get my extruder to begin the print centered on the build plate. 2. Unless I set the software end stop limits to falby pRO84 - Prusa i3 and variants