I found it out with the help of a friend. It was a burnt driver. Thanks to everyone who answeredby nerdmor - Prusa i3 and variants
Quotemsaeger Quotenerdmor Just joined The forum so I could ask this. I am new at 3D printing. Built my Prusa from a kit and it was working wonderfully until today, when, mid-print, the extruder motor simply stopped working. I have very little knowledge about electronics, but I did do the obvious and switched the X axis and the extruder plugs on the Arduino board. The extruder motor did run, so tby nerdmor - Prusa i3 and variants
Just joined The forum so I could ask this. I am new at 3D printing. Built my Prusa from a kit and it was working wonderfully until today, when, mid-print, the extruder motor simply stopped working. I have very little knowledge about electronics, but I did do the obvious and switched the X axis and the extruder plugs on the Arduino board. The extruder motor did run, so the motor isn't busted, norby nerdmor - Prusa i3 and variants