Hello all, I want to setup auto leveling using the stock/factory endstop. My Folger Tech 2020 i3 is bone stock in hardware and software. I have read 60 - 70 posts in this thread and now I am more confused than ever. Is there a step-by-step wiki or post I can follow to get auto leveling up and running with what I stated above? Any help would be much appreciated!by Trilithon - Prusa i3 and variants
You have a link or STL file for that duct and mount? QuoteCyril So I finally added a cooling fan, and printed a benchy with 0.1 as layer height, slowing done the speeds of perimeters to 60%. It came out pretty well particularly regarding the bridges even if I had a Y shifting (I guess this is my bad motor I managed to fixed myself). Here are some pictures, let me know what do you think. (all tby Trilithon - Prusa i3 and variants
QuoteWilberMaker Is there any magic trick to getting the filament to stick to the bed? I'm pretty sure it is level. Might have a question about the zero height of Z. I have the tip almost touching the glass. What else might I check? Still a newb here, I use Atomic filament - PLA, blue tape the glass, .004" feeler gauge for extruder height, 35c bed temp and have no issues so far.by Trilithon - Prusa i3 and variants
Sooooo.... I threw my printer together a week or so ago and have been getting some good prints. My only concern was the X axis chatter and X axis motor temp.... scorching! I was afraid, in my advanced years ( read shaking hands and eyesight) to check stepper voltage. Tonite, I got the nerve to check it. X voltage was 4.7V! I tuned it down to 240mV and now the thing is whisper quiet! All otherby Trilithon - Prusa i3 and variants
QuoteK4DSP Just received my 2020 i3 this week. First 3D printer, and I'm doing a lot of reading, reviewing the build instructions, and just found this forum and thread. I just have a few questions. I'm planning to use Rippa's Marlin firmware right out of the chute instead of the firmware referenced by Folger Tech. Is this a good idea? Will it "just work" with the 2004 LCD? I'm familiar with theby Trilithon - Prusa i3 and variants
QuoteCreativeBR The wiki page says: "Please note that you will need to make some changes to your printer to get this working correctly/properly (unless you moved your X-endstop to the left side): - Move your X-endstop connection on your RAMPS board one set of pins over, to position 6 - In your host software, change X-endstop setting to MAX" So it seems that the X endstop to the left side is enoby Trilithon - Prusa i3 and variants
Ok, what do I have setup incorrectly to cause reverse lettering? It displayed correctly in Repetier. I am using the default files from the Folger google drive.by Trilithon - Prusa i3 and variants
Hmmm, I think this may put my horizontal rod in a bind.... Who do I contact? Or I'll just 'adjust' it......by Trilithon - Prusa i3 and variants
Just got my kit, everything looks good. Time to do some reading before building. Also, thanks for the pack of Jelly Belly jelly beans .... I ate them, were they supposed to be used for something else? Trilby Trilithon - Prusa i3 and variants