Therippa's Marlin firmware for the Folgertech 2020 Prusa i3. I figured out the problem. My endstop settings were preventing the printer from moving during a G29. I finally have this printer usable. Working on Calibration now. Thanks for replying.by Duteycs - Prusa i3 and variants
I have entered G29 into the start code. It doesn't perform a grid probe it lowers the z axis until the probe triggers then starts printing.by Duteycs - Prusa i3 and variants
Does anyone that has this working know why the machine will not probe multiple places before printing? I don't understand why nothing I've tried fixes this. I cannot get proper auto_leveling. I finally have it moving properly with Auto_bed leveling enabled. It homes z to 0 then begins to print I have entered the rectangle parameters and change grid points to 3 instead of 2, but I get nothing forby Duteycs - Prusa i3 and variants
I have mine up and running sort of. I'm using the forked marlin firmware and have everything working. II have added an inductive sensor and have it working as a z endstop, I'm not able to get the probe to check multiple points before printing it just drives the z axis down until the inductive sensor is activated and then begins printing from there. I switched to auto leveling because my print surby Duteycs - Prusa i3 and variants
Hi Everyone, I finally got my printer assembled and had issues with my bed not being level. This made bed leveling very difficult I kept getting level around the edges and the head would scrape the center of my bed, I'm using an aluminum plate as my bed so I loosened up all of the level screws until the bed was flat again. I used a piece of glass I was intending to use to check how flat the bedby Duteycs - Prusa i3 and variants