Hey Supermec.. Thanks for the lead, but it turned out that this isn't the issue. It looks like steps/mm is okay. BUT, I am going to remove all configuration and start over - so maybe that will help (maybe it is displaying a value it isn't using?).by joemc3 - Prusa i3 and variants
Below is an email describing x-axis rod length issue (fixed) and my current issue of my extruder motor not working. Figured I'd post it here in case it can help others (or if anyone has insight into my current issue). Thanks for the quick feedback last week. I had contacted you about the x-axis rods being too long and you responded that it may be slag in the holes. It was (motor side, idler siby joemc3 - Prusa i3 and variants
Below is an email describing x-axis rod length issue (fixed) and my current issue of my extruder motor not working. Figured I'd post it here in case it can help others (or if anyone has insight into my current issue). Thanks for the quick feedback last week. I had contacted you about the x-axis rods being too long and you responded that it may be slag in the holes. It was (motor side, idlerby joemc3 - Prusa i3 and variants