Quotehobbes Are you guys kidding me? So the estimated delivery is complete bogus? I originally ordered the acrylic Folgertech Prusa i3, and then maybe a half-hour later decided to go with the aluminum one instead. I emailed Folgertech to cancel the order and give me the 2020 version, but Dan (who also no longer works there, btw), told me it was already being packed and he couldn't stop the waby therippa - Prusa i3 and variants
Nevermind, solved the other problemby therippa - Prusa i3 and variants
Quoteanimoose Quotetherippa Did anyone else have a problem with X home? I followed the steps in animoose's blog... physically, my X limit switch is on the right and the Y one is at the back. The X motor connector is reversed compared to the others (red wire to the left). This is exactly as shown in the construction guide. in configuration.h, I have #define INVERT_X_DIR false, and #define X_HOMEby therippa - Prusa i3 and variants
Did anyone else have a problem with X home? I followed the steps in animoose's blog... physically, my X limit switch is on the right and the Y one is at the back. The X motor connector is reversed compared to the others (red wire to the left). This is exactly as shown in the construction guide. in configuration.h, I have #define INVERT_X_DIR false, and #define X_HOME_DIR 1. in pins.h somewhereby therippa - Prusa i3 and variants
Quoteanimoose Quotetherippa Did anyone else have problems with step 16? The motor brackets are held in with three bolts/t-nuts (two on the top rail, one on the side). In the instructions, when they lift the motors all the way up, it looks like they remove the bolt on the side rail. Anyway, after putting it all together, and using all 3 bolts, the z-axis chrome rods are definitely bowing a littby therippa - Prusa i3 and variants
Did anyone else have problems with step 16? The motor brackets are held in with three bolts/t-nuts (two on the top rail, one on the side). In the instructions, when they lift the motors all the way up, it looks like they remove the bolt on the side rail. Anyway, after putting it all together, and using all 3 bolts, the z-axis chrome rods are definitely bowing a little bit to fit into the acrylby therippa - Prusa i3 and variants