I've not compiled RC5 yet. I used MKS_BASE on RC4 for testing, but still using 1.0.2-1 with 33 for MOTHERBOARD for regular printing. Reason why I am asking is here's the new MKS_13.h: /** * Arduino Mega with RAMPS v1.4 adjusted pin assignments * * MKS v1.3 (Extruder, Fan, Bed) * MKS v1.3 (Extruder, Extruder, Fan, Bed) * MKS v1.4 (Extruder, Fan, Bed) * MKS v1.4 (Extruder, Extrudeby jeff6845 - Firmware - Marlin
Why was MKS versions 1.3 and 1.4 separated out in RC5 from MKS base (earlier versions)? I cannot see any difference, perhaps coming? MKS_BASE was worked for me.by jeff6845 - Firmware - Marlin
Solved it.... display setting was wrong. Using BOARD_MKS_BASE, btw.by jeff6845 - Firmware - Marlin
I've tried defining MOTHERBOARD with the following: BOARD_MKS_BASE, BOARD_RAMPS_14_EFB, and BOARD_RAMPS_13_EFB (equivalent to 33 which I am using fine with 1.0.2-1) with no luck. Display just shows row of blocks on lines 1 and 3 on power on and that's it. Any suggestions for which value to use for "#define MOTHERBOARD" in Configurations.h?by jeff6845 - Firmware - Marlin