Not a developer but can you move your limit switches to coincide with the position you want??? if not I ran into a similar thing while trying to zero my z height. Im sure there is a better/safer method but I temporarily commented out #Define _Min_Pos. if this works, i would guess there is some "offset" setups that would allow you to get your extruder where you need it with the #Min_Pos setby Key0nee - Firmware - Marlin
Hello JustSumGuy, Thanks for the quick response... So I got 1.1.8 (also worked with Marlin 1.1.7) compiled and uploaded to my Creality CR10 Melzi board with full LCD support and it appears to be working correctly. Im not a developer but I still think my initial problem is the memory space of the Melzi board... To try and prove it this was my approach. 1. First I tried to compile right aby Key0nee - Firmware - Marlin
Hello all, Trying to upgrade my CR-10 to 1.1.7 and it wont compile when I enable all the features I want. And I get a warning that “Text” will not fit into text region then the linker throws a fault. However it will compile fine if i compile without lcd support. Ive also tried compiling with lcd support but without bilinar bed leveling enabled, and it compiles fine. If it is too big, are thby Key0nee - Firmware - Marlin