So I've checked on this and it doesn't seem to be the issue. Any other ideas?by SnoopD0ug - Firmware - Marlin
Thank you! I'll give that a shot right now. In black and white 1/32 stepping makes me think that it's capable of more precise movement there fore capable of higher quality prints. Is the hardware mechanically able to 'tell a difference'?by SnoopD0ug - Firmware - Marlin
Good evening all, I apologize for the poor subject line. The short story is that the printer 'thinks' that the rear corner of the bed is almost in the center of the bed and all the movements it makes are about 1/3 about what they should be. Example: I move the head 50mm but it physically only moves about 2.5cm. The long story is that it was an anet A8 that's had every component replaced (literaby SnoopD0ug - Firmware - Marlin