Hi guys, I have a printer that I've modified to a different type of printing for my school work (basically I'm just using the movement part of Marlin), but i'm having an issue. See the Gcode sample bellow. The commands are sent just for one axis at a time and when X is moving, Y also moves tiny bits... I would like to have this completely independent. Also the representations look good, thatby nunzr - Firmware - Marlin
I don't think so, but I will test for sure. Thank you.by nunzr - Firmware - Marlin
Hi guys, I would like to ask for some ideas, because I've exhausted mines abut this. For the Z axis I was using a stepper motor attached to some guide rails and was managed to get it working fine, but had to upgrade to a new motor with a 1:26.85 reduction gearbox. The problem is, to any value of steps per mm that i put in from 50 to 2600 (the calculation of the correct value for this setup is 2by nunzr - Firmware - Marlin